Final Post/Presentation

https://docs.google.com/presentation/d/1oOcmNEuVlZs9eJQZc0rgGhamK1D2Vk-Sq6tOwmdZjHA/edit#slide=id.g3b804f56b6_0_110

Comments

Post a Comment

Popular posts from this blog

blog 9

Image
The next step was to start to finish the top of the stool. Because of the huge crack down the center I needed a way to make sure the crack doesn’t spread and to keep it contained. You can do this in three different ways. You can use epoxy, a butterfly, or a Dutchman. Epoxy is just filling the crack with a mixture of plastic fillings and wood dust to give it color. You mix the chemicals together and then add the wood dust and mix it into a peanut butter type thickness and then spread it into all of the cracks on the piece. You lay it in thick so make sure it goes all the way in. On my stool I used epoxy and a butterfly. A butterfly is a wooden insert that you put in a middle of a crack to keep it from spreading. You first have to cut out a butterfly. There are many models you use that have different sizes. You trace them onto a piece of wood and then cut out the major shape with the belt saw. Then you sand it down so it is similar to the model. Next you use the router to cut the hol...
Read more

blog 6

Image
After routing the table you check to see if you missed anything by looking at the table with different light and feeling for any bumps or lines. This is important because when the finish goes on it makes the board more colorful and so all the mistakes will be very visible if you don’t sand them out. After the 220 final sand the table somehow feels a thousand times soften than the 180 grade. At this point all the heavy lifting and long hours working the flattener and sanding all feels worth it. These final stages make the whole process worth it. After the 220 sand you put the finish on. The finish is a combination of three different oils each making up 1/3 of the mixture. Each oil has its own use. One makes the colors pop, another protects the table with a strong outside layer, and the other adds a shine. You paint the oil onto the table in a relatively thick coat. You paint it going with the grain so it works its way into the wood. After the whole table is covered in the oil you imme...
Read more

Blog 10

Image
The final step is adding the legs to the stool. The first step is the cut out the rectangular blocks that will make the legs. They have to be the right length and thickness so they fit on the spinning machine. The rectangular blocks were about 19 inches in length which is much to long for a stool leg but it is better to have more than less. You crank the wood into the machine and when you turn it on it spins the wood insanely fast. It’s almost like a horizontal pottery wheel. Then you inch the blade closer to the spinning block, slowly cutting it down to the shape of a stool leg. You have a guide that makes sure you cut the right shape. You have to cut relatively slow to make sure wood doesn’t chip and has a clean cut. When you finish cutting it into the right shape you then sand it while its spinning but just to 80 grade. Next you can put the legs in. you drill 4 angled holes in the stool and then cut slices into the top of the legs themselves so once they are in, you can wedge them...
Read more